XDS H.110 cPCI High Density
Loop Start Board
 

 
 
Product Part Number: 258L040 (32 port)
Product Part Number: 258L051 (16 port)

PC Form Factor: 6U CompactPCI
TDM Bus Type: H.110

Bus Capacities:
H.110 - 4096 timeslots
Analog Ports - 16 (Base board) or 32 (with optional mezzanine board attached)

The H.110 cPCI loop start board provides sixteen or thirty-two ports, each providing a complete analog loop start interface. Each port is capable of seizing the line, detecting the presence or absence of loop current, and detecting inbound ring signals with a variety or frequencies and cadences. The board includes Caller ID resources to support Calling Number Delivery and Calling Name Delivery as well Calling Identity Delivery on Call Waiting. Internal DSPs provide DTMF detection and generation, energy detection, and call progress tone generation. European call progress tones and a 1004Hz calibration tone are also available. Battery polarity reversal detection and custom tone generation are also supported.

Click here to download the XDS H.110 Loop Start Board technical manual

  
Additional Product Specifications


Analog Interface:
Ports: 16 (Base board) / 32 (with optional mezzanine board attached)
Connector: Dual RJ21 on cPCI rear panel

DSP Resources:
DTMF Detector (each port)
Energy Detector (each port)
DTMF Generator (each port)
North American and European Call Progress Tone Generation (each port)
1004Hz Calibration Tone Generation

Caller Identity:
Calling Number Delivery: supported
Calling Name Delivery: supported
Calling Identity Delivery on Call Waiting: supported

Additional:
Custom tone generation: supported
Programmable Hook-Flash detection: supported
Programmable Call Waiting Detection: supported
Adjustable Gain Control: supported, per port
cPCI Hot-Swap: supported

Temperature Extremes:
Operating: 0°C (+32°F) to +50°C (+122°F)
Storage: -40°C (-40°F) to +70°C (+158°F)

Ambient Humidity:
Designed to withstand ambient relative humidity from 0% to 95% non-condensing in both operating and storage conditions.

Mechanical:
Designed to conform to PICMG® mechanical specifications for 6U CompactPCI cards.

MTBF:
50,000 hours

Electrical Requirements:
+5 volts +5% @ 1.5 amps maximum
+12 volts, +3 volts, and -5 volts are not required