XDS H.110 cPCI 2/4-Wire E&M
Line Interface Board (16-port)

 

 
 
Product Part Number: 258L031

PC Form Factor: CompactPCI
TDM Bus Type: H.110

Bus Capacities:
H.110 - 4096 timeslots
Analog Ports - 16

The E&M line interface board contains sixteen ports, each capable of 2-wire or 4-wire operation, using type I or type V signaling protocols. Signalling protocols and port types are programmed on a per-port basis. Individual ports may also be programmed for Radio Interface operation, allowing independent control of the E&M signalling leads on the application level. On-board DSP resources include DTMF detection and generation, as well as energy detection, North American / European call progress tones, and a 1004Hz calibration tone. All H.110 compatible clock modes are supported.

Click here to download the XDS H.110 2/4-wire E&M technical manual

  
Additional Product Specifications


Analog Interface:
Ports: 16
Signalling: Type I / Type V (software configurable)
Port Types: 2-wire, 4-wire, Radio Interface
Connector: Dual RJ21 on rear I/O panel

DSP Resources:
DTMF Detector (each port)
Energy Detector (each port)
DTMF Generator (each port)
Call Progress Tone Generation (each port)
1004Hz Calibration Tone Generation

cPCI Hot Swap:
Supported

 Temperature Extremes:
Operating: 0°C (+32°F) to +50°C (+122°F)
Storage: -40°C (-40°F) to +70°C (+158°F)

Ambient Humidity:
Designed to withstand ambient relative humidity from 0% to 95% non-condensing in both operating and storage conditions.

Mechanical:
Designed to conform to PICMG® 2.0 mechanical specifications for 6U CompactPCI cards.

MTBF:
50,000 hours

Electrical Requirements:
+5 volts +5% @ 1.5 amps maximum
+12 volts, +3 volts, and -5 volts are not required
-48 volts maximum current per port 30mA